Skutch-electronics CK-2 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení Skutch-electronics CK-2. Skutch Electronics CK-2 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 5
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Page 1 of 5
"Telecommunication Products to solve Telecommunication Problems"
CK-2
Promotion-On-Hold Module
(For GE 29487GE2 and 29488GE2)
Introduction
Thank you for purchasing
the Skutch CK-2 Promotion-
On-Hold Module for the
GE 29487 and 29488 four
line telephones. The CK-2
supplies Promotion-On-
Hold whenever any call is
placed ON HOLD with the
telephone's hold button. The
CK-2 not only supplies
Promotion-On-Hold, but it
also removes the annoying
"BEEPS" that these
telephones produce every 3
seconds when the phone is
placed on hold. The CK-2
will supply Promotion-On-Hold to callers that are placed ON HOLD ONLY from the
GE 2-9487 or 2-9488 telephones. Other makes and/or models of telephones can be used
with the CK-2 but they will not produce Promotion-On-Hold when placed ON HOLD.
Installation
There are two methods that can be used to install the CK-2 module. It basically depends
on how close the telephones are together. If all of the telephones are within 25 feet of a
central point, then method #1 can be used. In this case modular cords MUST be run
directly from the CK-2 box to each of the telephones. If your telephones are spread out
more than 25 feet apart, then you will need to use method #2. In this case you will have
to have a qualified person install four telephone jacks in front of your all of your
telephones. The CK-2 will have to be connected to these jacks. In this case the wiring to
the telephones remain unchanged. See method #2 for more details.
Modular Cords
Power Cube
Audio Cord
Zobrazit stránku 0
1 2 3 4 5

Shrnutí obsahu

Strany 1 - Installation

Page 1 of 5 "Telecommunication Products to solve Telecommunication Problems" CK-2 Promotion-On-Hold Module (For GE 29487GE2 and 29488GE2)

Strany 2 - Method #1

Page 2 of 5 Method #1 Installation: This method should only be used when all phones are within close proximity of each other. Up to five telep

Strany 3 - Method #2 Installation:

Page 3 of 5 5- Connect a telephone cord from each line 3&4 jack on each telephone, a CK-2 jack that is labeled "Phone 3 & 4". Order

Strany 4 - To ALL Telephones

Page 4 of 5 Red = Line #1 Ring GREEN CORDS are for Testing ONLY! Green = Line #1 Tip They are removed before installing t

Strany 5 - • ONE YEAR LIMITED WARRANTY

Page 5 of 5 Operation: Operation is simple. When you place a caller ON HOLD from any of the GE 29487GE2 or 29488GE2 phones, the corresponding "Li

Komentáře k této Příručce

Žádné komentáře